Hi,
thanks for your suggestions.
ad gauges:
I have on TODO list possibility to save/restore gauges configuration (I know, long time, but it is near, I hope
Then, every user can modify current and/or create new gauges with any PID. For example with temperature sensor voltage, of course.
There are many versions of engines and every system is different. Automatic reconfiguration of gauges is big load for me. I would like to give freedom to user invention.
I would like to do save/restore action little bit smarter than normal load/save to disk folder.
Would like to give possibility to load/save configuration for specific "engine type" class. And there will be possibility
to tick some switch with "autoload this gauges whenever connection to this type of engine will be connected".
Then, users can create gauges set by self (and can share this config file with others, of course) for specific engine type.
This gauges-set could be focused, for example, for CHT diagnostic, or for pulsewidth+fuel consumption, etc.
ad consumption:
hmm, it needs some more processing to calculate consumption. It can not be achieved by simple PID reading.
There must be some type of scripting for "specific" (understand user created) PIDs with possibility to calculate average values, etc. It could be fine for more values. For example acceleration calculation/measuring, etc.
Have it on TODO too.
ad KOEO/R:
I know, but it is little annoying, not as big ....
But, it could be done simply if someone measure time for both actions. Thanks in advance.
(I don't have EEC IV with LEDs here, yet)